51
8
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENOM00070-A
ENOW00890-0
Before installing the outboard motor on the
boat, hang the outboard motor with the
hoist or equivalent device by attaching the
engine hanger to the outboard.
Use the hoist with allowable load is 150 kg
(330 lbs) or above.
ENOW00064-0
Engine may be hot immediately after oper-
ating and could cause burns if touched.
Allow engine to cool down before attempt-
ing to carry the outboard.
1. Stop the engine.
2. Remove the top cowl.
3. Disconnect the fuel connector, the
remote control cables and the battery
cords from the outboard motor.
4. Attach the hoist hooks to the engine
hanger.
5. Remove the outboard motor from boat
and completely drain the water from
the gear case.
ENOM00071-A
ENOW00933-0
Be sure to disconnect fuel connector
except when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00065-0
Close air vent screw of fuel tank before
carrying or storing outboard motor and fuel
tank, or fuel may leak, potentially catching
fire.
ENOW00066-0
Do not give a shock to an outboard
motor during transportation. It becames
a cause of breakage.
1. Removing the outboard motor
WARNING
CAUTION
2. Carrying the outboard motor
WARNING
WARNING
CAUTION
E15__US_EN_141125N.book 51 ページ ２０１４年１２月２６日 金曜日 午後２時４６分
To Next Page
Loading...
Need help?
General
