ENGINE OPERATION 49
7
1. Power
2. Manual
ENOM00068-A
ENOW00051-0
During shallow water operation, be careful
not to place your hand between the swivel
bracket and the clamp bracket. Be sure to
tilt the outboard motor down slowly.
ENOW00053-0
While in shallow water drive position, do
not operate the outboard motor in Reverse.
Operate the outboard motor at slow speed
and keep the cooling water intake sub-
merged.
ENOW00054-0
Do not overtilt outboard motor when driv-
ing shallow water, or air may be sucked
through water inlet and sub-water inlet,
potentially leading to engine overheating.
1. Water inlet
2. Sub-water inlet
Manual tilt type
1. Shallow water running position:
Put the reverse lock lever in the tilt up
position, and tilt up the outboard motor
to put the outboard motor in the shal-
low water running position.
1. Reverse lock lever
2. Tilt up position
3. Tilt down position
2. Return to normal running position:
Put the reverse lock lever in the tilt
down position, slightly lift up the out-
board motor, and then put it down.
9. Shallow water operation
WARNING
CAUTION
CAUTION
1
2
3
ENOF00059-0
E15__US_EN_141125N.book 49 ページ ２０１４年１２月２６日 金曜日 午後２時４６分
To Next Page
Loading...
