BRP EVINRUDE E15R4 - Page 43

ENGINE OPERATION 43
7
2. Turn the main switch key to the OFF
position or push the stop switch. ( Do
not forget to turn the key off).
1. Control lever
2. Mine switch key
ENOW00869-0
After stopping the engine:
 Close the air vent screw on the tank cap.
 Disconnect the fuel connector of the
engine and the fuel tank.
 Disconnect the battery cord, after each
use.
Emergency engine stopping
Remove stop switch lock to stop the
engine.
1. Stop switch
2. Stop switch lock
1. Stop switch
2. Stop switch lock
ENOM00910-0
Spare emergency stop switch lock
A spare emergency stop switch lock is
provided in the tool bag.
When used as described, the emergency
stop switch clip and emergency stop
switch lanyard system stops the engine if
the operator falls away from the controls.
When an operator falls into water, be sure
to use emergency stop switch lock of the
spare.
Be sure to confirm the spare stop switch
lock is in the tool bag before begin to oper-
ate.
WARNING
N
R
F
2
1
ENOF00881-0
ON
OFF
START
2
ENOF00882-0
1
2
ENOF00314-C
1
2
ENOF00884-0
E15__US_EN_141125N.book 43 ページ ２０１４年１２月２６日 金曜日 午後２時４６分