14
Network Setup
IMPORTANT: Set “ENGINE OPTIONS” on Evinrude E-TEC outboards
before power is applied to the I-Command Network.
Engine Options
Use Evinrude Diagnostics software to set “ENGINE OPTIONS”.
Settings include:
•Set multi engine identity (engine count and engine position)
•Calibrate trim sensor
•Water pressure transducer (ONLY if equipped with water pressure
transducer that is installed on engine block, P/N 5006214)
See your dealer if set “ENGINE OPTIONS” has not been completed.
Evinrude Diagnostics software, set engine
options
To Next Page
Loading...
