6
Instruments
Spacing of Instruments
The minimum distances between instruments on a panel should be as follows:
•3 13/16 (112 mm) center to center for 3 1/2 in. instruments
•3 1/4 in. (95.5 mm) center to center for 3 1/2 in. instruments to 2 in. instruments
•2 5/8 in. (77 mm) center to center for 2 in. instruments
Panel Thickness
Instruments can be mounted in panels up to 1 in. thick.
Hole Sizes
IMPORTANT: Check space behind panel to be sure adequate clearance for instruments exists before drilling
panel.
3 1/2 in. Multifunction Gauge
Cut 3 3/8 in. (99 mm) diameter hole in panel for 3 1/2 in. instruments.
Fastening to Panel
Insert instrument into panel hole. Install bracket and tighten nuts finger tight.
To Next Page
Loading...
