87
Engine Warnings
The I-Command gauges monitor engine conditions and display warnings in the event of a malfunction. Refer
to the outboard Operator’s Guide if any engine warnings are displayed.
WARNING MESSAGE
DISPLAYED
POSSIBLE CAUSE / PROCEDURE
Check Engine
A “Check Engine” condition may be activated when a critical engine con-
dition occurs, or when a service is required:
· A “Critical” condition will activate S.A.F.E. (RPM reduction) - Seek assis-
tance to return to safe harbor immediately and see your dealer.
· A minor service issue will NOT activate S.A.F.E. - See your dealer as
soon as practical.
Over Temperature
Engine or EMM above temperature range. Check cooling water to water
intakes.
Low Oil Level A low oil level has been detected in the oil tank. Fill tank.
Low System Voltage A low voltage condition has been detected. See your dealer.
Rev Limit Exceeded The RPM limit has been exceeded. Reduce throttle.
Throttle Position Sensor A throttle position sensor fault has been detected. See your dealer.
Power Reduction EMM has activated S.A.F.E.
Neutral Start Protection Attempt to start engine while in gear. Shift to neutral.
Engine Shutting Down EMM has activated engine shutdown.
To Next Page
Loading...
