BRP I-Command Evinrude Etec Series - Change Units

26
Change Units
This example will change the water pressure gauge to read from psi, to bar. Other units can be changed in the
same manner.
1. Press MENU. Use the UP or DOWN buttons and select SYSTEM SETUP.
Press ENTER.
2. Use the UP or DOWN buttons and select CHANGE UNITS.
Press ENTER.
MENU
DOWN
UP
EXIT
PA
GES
ENTER

Customize
Pages
Screen
Audio Setup
System Setup

MENU
DOWN
UP
EXIT
PAGES
ENTER

Fuel Setup
Engine Displayed
Speed Range
Press Ranges
Eng Warnings
Change Units

MENU
DOWN
UP
EXIT
PA
GES
ENTER
MPH
WTR:P
GND:S
0 60
0 40
10 30
20
15 45
30
psi
1
2