BRP I-Command Evinrude Etec Series - Screen Settings; Change Contrast

20
Information Displays
Pages are an essential part of the I-Command Digital gauge.
Press the ENTER button repeatedly to scroll through the factory default
pages.
There are seven factory default pages:
•Tachometer - displays engine rpm
•Speedometer - displays ground speed (GND:S)
•Fuel Level - displays fuel level percent (FUL:L)
•Engine Trim - displays engine trim percent
•Battery Volts (Batt Volt) - displays battery voltage
•Engine temperature (Eng Temp) - displays engine operating tempera-
ture. in degrees Fahrenheit or Celsius. See “Change Units” on page 26 to
customize this display.
•Fuel Flow - displays default fuel management information of ground
speed, fuel remaining (Fuel Rem), and fuel level. See “Fuel Management
Options” on page 66 to customize this display.
The I-Command gauges are ready for operation.
MENU
DOWN
UP
EXIT
PA
GES
ENTER
0 70
10 60
20 50
30 40
x 100
RPM
4257
MENU
DOWN
UP
EXIT
PA
GES
ENTER
0 70
10 60
20 50
30 40
MPH
GND:S
34
Tachometer
Speedometer