BRP I-Command Evinrude Etec Series - Configure Fluid Level Sensor

58
Configure Fluid Level Sensor
This example illustrates Fluid Level Sensor Configuration for the second of two fuel tanks. Fluid level sensors
for other fluid tanks will configure similarly.
1. Press MENU. Use the UP or DOWN buttons and select SYSTEM SETUP.
Press ENTER.
2. Use the UP or DOWN buttons and select BUS DEVICES
Press ENTER.
3. The gauge will search for devices.
MENU
DOWN
UP
EXIT
PA
GES
ENTER

Customize
Pages
Screen
Audio Setup
System Setup

MENU
DOWN
UP
EXIT
PA
GES
ENTER

Eng Warnings
Change Units
Bus Devices
Sleep Mode
Sonar Alarms
Eng/Tank Cfg

12
MENU
DOWN
UP
EXIT
PA
GES
ENTER

Eng Warnings
Change Units
Bus Devices
Sleep Mode
Sonar Alarms
Eng/Tank Cfg

Message
Searching
Bus
Devices...
3