BRP I-Command Evinrude Etec Series - Page 55

53
3. Use the UP or DOWN buttons to select STAY-ON TIME.
Press ENTER.
4. The stay-on time ranges between two and fifteen seconds. Set the
desired stay-on time using the UP or DOWN buttons.
Press ENTER when finished.
Note: The stay-on time selected applies to all monitored categories.
MENU
DOWN
UP
EXIT
PAGES
ENTER

RPM
Engine Trim
Trim Tabs
Rudder
Stay On Time

MENU
DOWN
UP
EXIT
PAGES
ENTER

Add Page
Remove Page
Page Scrolling
Popups Setup

Set Time
5 sec
Press ENTER
when finished
3
4