BRP I-Command Evinrude Etec Series - Page 75

73
4. Use the UP or DOWN buttons and select UNCFG PRESS.
Press ENTER.
5. Press ENTER to configure Pressure Sensor.
6. Use the UP or DOWN buttons to make selection.
Press ENTER.
7. The gauge will change the device setting and return to the BUS DEVICES
list.
Press EXIT three times to return to gauge display.
MENU
DOWN
UP
EXIT
PA
GES
ENTER

Water Temp
Fuel Tank 1
UnCfg Press
Water Press
Oil Tank
Storage Device

MENU
DOWN
UP
EXIT
PA
G
ES
ENTER

Water Temp
Fuel Tank 1
UnCfg F Lev
Water Press
Oil Tank
Storage Device

Configuring
Press ENTER
to Configure
Press Sensor
MENU
DOWN
UP
EXIT
PA
GES
ENTER

Fuel Pressure
Trns Oil Press
Pitot Speed
Eng Bst Press
Eng Oil Press
Eng Water Press

MENU
DOWN
UP
EXIT
PA
GES
ENTER

Fuel Pressure
Outside Temp
Inside Temp
Engine Room
Live Well
Eng Water Press

Message
Changing
Device
Settings
6
4
75