BRP I-Command Evinrude Etec Series - Updating Gauge Software

91
DESCRIPTION POSSIBLE CAUSE / PROCEDURE
Water depth does not display Requires input from NMEA 2000 depth transducer.
Sea water temperature does not
display
Requires input from NMEA 2000 temperature transducer.
Fuel tank level does not display
Requires fuel level sensor. See “Configure Fluid Level Sensor”
on page 58 and “Fuel and Fluid Level Sensor Calibration” on
page 61.
No “Fuel Manager”
Requires memory module and setup of the I-Command display.
See “Fuel Management” on page 64.
No “Fuel Economy” display for Fuel
Management
Requires input from NMEA 2000 GPS receiver. Also see “Dis-
play Fuel Economy” on page 30.
Oil tank level does not display
Requires input from oil tank sender. Each oil tank uses an out-
board position specific converter. See “Configure Fluid Level
Sensor” on page 58.
Engine water pressure does not
display
Requires input from a water pressure transducer. See “Config-
ure Pressure Sensor” on page 72.
If using P/N 5006214 water pressure sensor (threaded into
engine block), use Evinrude Diagnostics Software set EMM. See
“Engine Options” on page 14.
Water pressure related fault codes
observed after initial setup
Check for incorrect water pressure transducer connections at
engine.
Note: I-Command device must be connected to device connector (center) of Tee-connector. Check condition of all
Tee-connector(s). Inspect pins and sockets of Tee-connectors and device connectors carefully.
Damaged or shorted connectors can damage 3 amp fuse.