Trademarks
Microsoft, Windows and Windows Vista are registered trademarks of Microsoft Corporation in
the United States and/or other countries
· Intel and Pentium are registered trademarks of Intel
Corporation or its subsidiaries in the United States and/or other countries · HP is a registered
trademark of Hewlett-Packard Company
· Netgear is a trademark of NetGear, Inc. · Adobe and
Reader are registered trademarks of Adobe Systems Incorporated in the United States and/or oth-
er countries · LabVIEW is a registered trademark of National Instruments Corp. in the United
States and/or other countries
· Neutrik is a registered trademark of the Neutrik Group worldwide ·
ICP is a registered trademark of PCB Group
Copyright © 2002 – 2009, Brüel & Kjær Sound & Vibration Measurement A/S
All rights reserved. No part of this publication may be reproduced or distributed in any form, or
by any means, without prior written consent from Brüel & Kjær Sound & Vibration Measurement
A/S, Nærum, Denmark
Safety Considerations
This apparatus has been designed and tested in accordance with IEC/EN 61010 – 1 and
ANSI/UL 61010 – 1 Safety Requirements for Electrical Equipment for Measurement,
Control and Laboratory Use. This manual contains information and warnings which must be
followed to ensure safe operation and to retain the apparatus in safe condition. Special note should
be made of the following:
Safety Symbols
The apparatus will be marked with this symbol when it is important that you refer to the as-
sociated warning statements given in the product documentation.
Earth (Ground) Terminal
Warnings
• This equipment must not be used for measurements on circuits directly connected to mains
voltage. Exceeding the specifications of this product may cause permanent damage and/or
cause the operator to be exposed to potentially hazardous voltages.
• Switch off all power to equipment before connecting or disconnecting their digital interface.
Failure to do so could damage the equipment.
• Whenever it is likely that the correct function or operating safety of the apparatus has been
impaired, it must be made inoperative and be secured against unintended operation.
• Any adjustment, maintenance and repair of the open apparatus under voltage must be avoid-
ed as far as possible and, if unavoidable, must be carried out only by trained service person-
nel.
• Do not dispose of electronic equipment or batteries as unsorted municipal waste
• It is your responsibility to contribute to a clean and healthy environment by using
the appropriate local return and collection systems
• Hazardous substances in electronic equipment or batteries may have detrimental
effects on the environment and human health
• The symbol shown to the left indicates that separate collection systems must be used
for any discarded equipment or batteries marked with that symbol
• Waste electrical and electronic equipment or batteries may be returned to your
local Brüel & Kjær representative or to Brüel & Kjær Headquarters for disposal
To Next Page
Loading...
Need help?
General
