Transport, Packaging and Storage
20 H155936_3_003
Do not Damage Air-tight
Packaging
The packaging is air-tight. Damage to the
barrier layer may render the contents
unusable.
Do not pierce.
Do not use sharp objects to open.
Component Sensitive to
Electrostatic Discharge
The packaging contains components which
are sensitive to an electrostatic discharge.
Only allow packaging to be opened by trained
personnel.
Establish potential equalization before
opening.
Protect from Heat Protect packages against heat and direct
sunlight.
Protect from Radioactive
Sources
Protect packages against radioactive sources.
Table5.1: Symbols on the Packaging
5.2 Inspection at Delivery
Upon receipt, immediately inspect the delivery for completeness and transport damage.
Proceed as follows in the event of externally apparent transport damage:
• Do not accept the delivery, or only accept it subject to reservation.
• Note the extent of the damage on the transport documentation or the shipper's delivery
note.
• Initiate complaint procedures.
Issue a complaint in respect to each defect immediately following detection. Damage
compensation claims can only be asserted within the applicable complaint deadlines.
5.3 Packaging
About Packaging
The individual packages are packaged in accordance with anticipated transport conditions.
Only environmentally friendly materials have been used in the packaging.
The packaging is intended to protect the individual components from transport damage,
corrosion and other damage prior to assembly. Therefore do not destroy the packaging and
only remove it shortly before assembly.
Handling Packaging Materials
Keep the original container and packing assembly, at least as long the warranty is valid, in
case the unit has to be returned to the factory. When the packaging material is no longer
needed dispose of in accordance with the relevant applicable legal requirements and local
regulations.
To Next Page
Loading...