Transport, Packaging and Storage
H155936_3_003 21
5.4 Storage
The following instructions should be followed when the flow unit will be stored for a longer
period:
• Before storage, the flow unit should first be thoroughly cleaned – this is described in
Removing the Flow Unit for Storage in the Transport Box [}41].
• Close the inlet and outlet of the sample line to protect the system against dust and dirt.
• Leave the glass flow tube connected to tube holder. Protect it against damage.
• Coil up the transfer line (Ø > 50 cm) and place the system into the transport box.
To store the flow unit temporarily when not in use, follow the instructions in the section
Removing the Flow Unit for Storage in the Transport Box [}41]
To Next Page
Loading...