Dismantling and Disposal
52 H155936_3_003
The WEEE register number can be found on the product label of the equipment. If you need
further information on the disposal of equipment or collection and recovery programs
available, contact your local Bruker BioSpin sales representative. Local authorities or
professional waste management companies may also provide information on specific waste
disposal services available in your area.
Disposal - End of Life (EoL) information: the common procedure as defined in the
sales contract with Bruker BioSpin
After the lifespan of an electrical and electronic product, Bruker BioSpin takes responsibility
for final disassembly and correct disposal in accordance with the European directive 2012/19/
EU WEEE 2.
Bruker BioSpin offers to take back the equipment (only for deliveries after 23.03.2006) after
termination of use at the customer site upon request by the customer. This request must be
affirmed when the equipment is ordered from Bruker BioSpin. Additional costs for dismantling
and transport service will apply!
Only 100% pre-decontaminated equipment can and will be accepted by Bruker BioSpin. A
release document for decontamination can be inquired from your nearest Bruker BioSpin
contact site, also to be used when repairs, going back to Bruker sites, are requested.
In compliance with WEEE II directive: 2012/19/EU
11.3 Disposal USA and Other Countries
Disposal of these materials may be regulated due to environmental considerations. For
disposal or recycling information, please contact our local office or your local authorities, or in
the U.S.A., contact the Electronics Industry Alliance web site at www.eiae.org.
To Next Page
Loading...