Bruker InsightMR - Technical Data; NMR System Requirements; Data Acquisition and Analysis; Recommended Temperature Range

Technical Data
H155936_3_003 53
12 Technical Data
NMR System Requirements
• 5 mm probe.
• 300-950 MHz magnet.
• AVIII console if InsightMR software is to be used (compatible with TopSpin 3.5pl2 and
above).
Data Acquisition and Analysis
It is highly recommended that InsightMR software (refer to the InsightMR release letter) is
used for data acquisition and analysis.
Recommended Temperature Range
The range in which temperature loss was measured is -5 °C to +60 °C. Temperature loss
using a thermostat type like the Julabo FE25-HE at -5 °C is < 4 °C and at +60 °C is < 2 °C
(remark: the loss is very dependent on the flow-power a thermostat can create, therefore
these numbers are based on the thermostat type we recommend).
The unit can be used at a wider range of temperatures according to the recommended
working temperatures of the wet materials, probe, pump and chiller.
Recommended Pressure
The recommended pressure is < 10 bar.
Wetted Materials for the Sample and Temperature Control Lines
Wetted materials for the sample lines are glass, PTFE (Teflon
®
) and FFKM (Kalrez
®
).
Wetted materials for the temperature control lines are PTFE (Teflon
®
), PEEK, POM (Delrin
®
).
Note: The temperature control line’s wet material only come in contact with the thermostat
liquid.