Flow Unit Installation
32 H155936_3_003
6.6 Software Configuration
6.6.1 TopSpin Configuration
• Launch the newly installed TopSpin.
• Select Expinstall (datastation) in the dialog that appears.
• Click on Next until the Expinstall is finished.
Refer to the TopSpin installation manual (Chapter 4, page 44 onwards) for details on
configuring TopSpin.
Figure6.17: Configuration Check
Once Expinstall is complete, configure IconNMR as described in the next section.
6.6.2 InsightMR Flow Mode Configuration
If not launched already, launch InsightMR by clicking on the desktop Icon. If the operating
system is Linux, there may not be a desktop icon and you may have to launch the program
by going to the folder applications/Bruker software/InsightMR.
Figure6.18: InsightMR Icon
This will launch TopSpin, InsightMR and IconNMR.
• Start Icon configuration by clicking on configuration in the icon below or typing iconc at
the TopSpin command prompt.
To Next Page
Loading...