Need help?Do you have a question about the Bruker LYNXEYE XE and is the answer not in the manual?
General| Brand | Bruker |
|---|---|
| Model | LYNXEYE XE |
| Category | Security Sensors |
| Language | English |
Details on authorized personnel for setup and operation of the LYNXEYE XE detector and adherence to safety practices.
Safety precautions related to X-ray equipment and radiation safety.
Procedure for powering up the LYNXEYE XE detector system.
Overview of system operation and data collection using DIFFRAC.COMMANDER for sample analysis.
Explains how to check discriminator settings for noise, fluorescence, and Kβ-suppression.
Important safety warnings and precautions during hardware installation and servicing.
Steps to introduce and configure the LYNXEYE XE detector within the DIFFRAC.Measurement Center.
Required procedures for trimming discriminators and performing energy calibration.
Procedure for setting the Veto threshold to eliminate unwanted photons.
Steps for trimming the low and high discriminators for optimal detector performance.
Setting discriminators for fluorescence reduction and Kβ-suppression.
Procedure for aligning the system and determining detector zero offset and resolution.
Steps to perform positional calibration using a reference material and specific settings.
Common issues and solutions for operating the LYNXEYE XE detector.
To Next Page