LYNXEYE XE Detector User Manual
DOC-M88-EXX240 V1 – 03.2014 4-7
4.1.5 Detector Status LEDs
Table 4.3 shows the different states of the detector’s LAN and back side LEDs.
Table 4.3: States of the detector’s LAN and back side LEDs
LED State
ALARM
(red)
Normal operation (blinking) or Alarm (lighting permanently).
Power
(green)
The LED stays turned on if power is applied and the firmware has been started or hangs.
BIAS
(orange)
The bias LED displays the status of the high voltage supply which produces the bias voltage
for the silicon strip detector.
LED off: Bias voltage is turned off.
LED blinking: Bias voltage is ramping up or down.
LED on: Bias voltage is on and equal to the set
value.
LAN LED
(green and orange)
The green LED is turned on when a hardware connection is established.
The orange LED shows the data transfer status.
RESET
Insert carefully a stump tool of approximately 3mm in diameter (like an Allen screw driver)
and press with little force the hidden RESET button.
To Next Page
Loading...