Bruker LYNXEYE XE - Select the Scan Parameters

LYNXEYE XE Detector User Manual
DOC-M88-EXX240 V1 – 03.2014 3-3
3.3.2 Select the Scan Parameters
The following parameters must be selected prior to running a measurement: scan type, start, stop,
speed, and increment (see Figure 3.1 and Figure 3.2). Additional settings may include divergence slit
size, rotation of the stage, and generator settings for KV and mA.
When using a PSD Fixed scan, the maximum scan length may vary and is dependent upon the Config
geometry angle.
To perform a measurement:
1. Turn the X-ray generator on.
2. Figure 3.1 and Figure 3.2 show the location of the parameters for different immediate measure-
ments. The fields show the actual settings for the current measurement.
Figure 3.1: A: Drop down menu for 1D-scans, B: Example of measurement parameters for fixed scan
Figure 3.2: Example of measurement parameters for locked coupled scan