LYNXEYE XE Detector User Manual
DOC-M88-EXX240 V1 – 03.2014 6-13
Figure 6.14: Diffractometer settings for Cu-radiation
Figure 6.15 shows the Discriminator screen with Advanced Settings opened. Energy, Mode and Gain
are by default set to ‘High Resolution’ for your tube. Values in Advanced Settings are inserted auto-
matically and normally need not to be changed. In case of low intensity, increase the Measure Time.
Modify the Discriminator Start/Stop values (check range by Discriminator Scan) if the result is not sat-
isfactory. The range must cover completely the Discriminator peak but should also not to be too wide.
To Next Page
Loading...