17
Programming the Thermostat
Setting the away temperature
1. Press the away button located under the display in the
center. You will see a triangle icon ( ) above the
away
button.
2. You will see the heating and cooling temperatures that
were set at the factory. To use these, just close the door.
3. To change the factory settings, press the
away button. You
will see the word heat flashing on the screen.
4. Press the
up or down button on the right side of the
display until you reach the correct temperature setting.
5. Press and hold the
away button for about three seconds.
The set temperature will flash, indicating that it saved
your settings.
6. To change the cooling temperature setting, press the
mode button until
you will see the word cool flashing on the screen.
7. Press the
up or down button until you reach the desired
temperature setting.
8. Press and hold the away button for about three seconds. The set tem-
perature and away arrow will flash, indicating that it saved your settings.
To Next Page
Loading...
Need help?
General
