8
Quick Start
Setting the time and day
You must set the time and day before you can use any
of the thermostat’s programming features.
1. Open the door.
2. Press the
d/h/m button. It’s on the lower right, under
the display screen. The day of the week will flash on
the display.
3. Press the
up or down button, located to the right of the
display, to change the day. Stop on the correct day.
4. Press the
d/h/m button again and the hour will flash
on the display.
5. Press the
up or down button to change the hour.
Stop on the correct number.
6. Press the
d/h/m button again and minutes will flash
on the display.
7. Press the
up or down button to change the minutes.
Stop on the correct minute.
8. Close the door.
To Next Page
Loading...
Need help?
General
