Operating the Thermostat
37
6. Install new batteries by matching the “plus” and “minus” ends
of the batteries with the “plus” and “minus” indicators you’ll see
outside the two white battery shapes in the space where the
batteries sit.
7. Snap the batteries into place.
8. Put the thermostat back on the
wall bracket by lining up the slot
on the bottom edge of the back of the thermostat with the lip on
the
wall bracket. You will feel the slot fit over the lip.
9. With the bottom of the thermostat attached to the bottom of the
wall bracket, bring the thermostat back to the wall. Line up the
latch at the top of the thermostat with the corresponding lip on
the wall bracket.
10. Lightly push the thermostat toward the wall. When the
latch and lip
are lined up properly, you will hear the thermostat snap into place.
To Next Page
Loading...
Need help?
General
