10 – 2 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Drive gear 2550
Removing the gear from the truck (not applicable for SWE120S)
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
10.3 Removing the gear from the truck
(not applicable for SWE120S)
1. Remove the covers.
The top cover is secured with Velcro tape. Be careful when
detaching the cover. Use of a suitable tool is recommended.
2. Cut off the cable ties of the cable duct on the transistor regulator
side and disconnect cable connectors X5 and X60.
3. Unscrew the retaining screws of the steering console and remove
the steering console and the tiller arm.
4. Disassemble the speed sensor and disconnect the cable
connections Q1 and B1.
5. Disconnect the motor cables and unscrew the retaining screws of
the motor
6. Lift the motor out of the truck.
7. Insert a 30 mm plug in the hole in the gear housing to prevent oil
leakage when the gear is removed from the truck.
8. Remove the cable duct.
9. Install the threaded M16 bar.
https://www.besttruckmanuals.com/
To Next Page
Loading...
