Hydraulic system 6000
Adjustment of the pressure limit valve
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 17 – 9
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
17.6 Adjustment of the pressure limit
valve
Location of the valve
The truck must be able to handle the rated load on the forks.
Place a rated load on the forks and verify that the truck is able to lift it.
If the truck cannot lift the rated load:
1. Prise off the sealing cap (a) around the pressure limiting valve
using a screwdriver.
2. Loosen the protective cover (b) (17 mm) by turning it anti-
clockwise. Remove the protective cover and washer inside it.
3. Loosen the lock nut (c) (17 mm) by turning it anti-clockwise.
b
a
c
https://www.besttruckmanuals.com/
To Next Page
Loading...
