Functions and parameters
General
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 6 – 1
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
6 – Functions and parameters
6.1 General
The chapter “Function and parameters” provides a basic description of
the truck's main functions and the control system parameters.
6.2 Function description
The section "Function description" provides a basic description of the
truck's main functions.
• Event – Use of one of the truck's main functions is referred to as an
event. All events are indicated by a number.
• Prior events – Indicates events which must have taken place
immediately before the current event in order for the latter to be
performed correctly.
• Action(s) – An action that the operator must perform in order for an
event to happen.
• Influencing factors – Conditions that must be fulfilled in order for an
event to happen. Certain parameter settings may also affect the
outcome of the event.
• Resulting conditions – Describe the key events that can be checked
in order to confirm a function.
Note that “resulting conditions” show what is expected when no error
conditions are present.
Text within square brackets [ ] refers to the electrical component names
in the truck's wiring diagram.
{High} means ≈ 24 V and {low} ≈ 0 V unless otherwise stated.
https://www.besttruckmanuals.com/
To Next Page
Loading...
