Buderus Logamatic 4122 User Manual

Standard functions
6
Logamatic 4121, 4122 and 4126 - Subject to technical modifications.
26
6.5.1 Setting the DHW temperature
You can change the DHW temperature as follows:
Hold down "DHW", and select the required DHW temperature with the rotary
selector.
Release "DHW". The newly selected DHW temperature is saved within
approximately 2
seconds. The permanent display will then appear again.
WARNING!
RISK OF SCALDING
from hot water!
The DHW cylinder temperature is preset to 60 °C. There is a risk of scalding
from hot water if your heating contractor has set the DHW temperature higher,
or has enabled the "Therm. Disinfect" function, and the heating water circuit of
your heating system is not equipped with a thermostatically controlled mixer.
Please note that fittings can also get very hot.
z In such cases, only ever draw off mixed water (hot and cold).
+
DHW
60°C
set
USER INFORMATION
For thermal disinfection, the DHW will be heated to at least 60 °C once or twice
per
week to kill off possible bacteria (e.g. legionella).

Buderus Logamatic 4122 Specifications

General

Brand	Buderus
Model	Logamatic 4122
Category	Control Unit
Language	English