Buderus Logamatic 4122 User Manual

Boiler flue gas test
10
Logamatic 4121, 4122 and 4126 - Subject to technical modifications.
77
10 Boiler flue gas test
During the flue gas test the MEC2 will show the display on the left.
WARNING!
RISK OF SCALDING
During the flue gas test, the water can reach a temperature in excess of 60 °C.
This creates a risk of scalding at the draw-off points.
z Only draw off mixed hot and cold water during or just after a flue gas test.
Note that when mono-lever mixer taps are in their usual position, the water
drawn may be too hot.
z Never draw off hot water only when using twin-lever mixer taps.
USER INFORMATION
Observe the relevant national requirements regarding limiting the flue gas
losses of your heating system.
z Arrange an annual flue gas test.
z The flue gas test is started at the boiler (see technical boiler
documentation).
Flue g.test act.
Boiler temp.
75°C

Buderus Logamatic 4122 Specifications

General

Brand	Buderus
Model	Logamatic 4122
Category	Control Unit
Language	English