Additional programming options
8
Logamatic 4121, 4122 and 4126 - Subject to technical modifications.
62
The display shows the stop point to be connected.
Hold down "Time" and turn the rotary selector clockwise, until the start point of
the second heating phase, i.e. the next consecutive heating phase, is displayed,
which you wish to combine with the first heating phase (here: "17:00").
If you have selected the start point of the next consecutive heating phase,
the
bottom line will show eight blocks, which are deleted in one-second intervals
from left to right. When no blocks are left both heating phases have been
combined.
The deleting process will be terminated if you release the "Time" key
prematurely or turn the rotary selector back. In this case all switching points
for
the heating phase remain active.
Release "Time" to save your input.
The new program that has been modified by the connection process is saved
under "Own program" and the heating circuit number (here: "2").
You can call up your new program by pressing "Prog" and turning the rotary
selector (Æ
Chapter 7.10).
Press "Back" to return to the permanent display.
To Next Page
Loading...
Need help?
General
