2 of 166
Warranty disclaimer
All information in the present documentation was prepared and compiled with great care and reproduced
in accordance with effective control measures. This documentation may contain errors, and the
information it contains and the corresponding technical data are subject to change without notice.
Reproduction of any part of this documentation or its processing or revision using electronic systems is
prohibited without the manufacturer's prior written approval.
Components, devices and measurement sensors made by burster praezisionsmesstechnik (hereinafter
referred to as the "product") are the result of targeted development and meticulous research. From the
date of delivery, burster provides a warranty for the proper condition and functioning of these products
covering material and production defects for the period specified in the warranty document accompanying
the product. However, burster waives any guarantee or warranty obligations or any additional liability for
consequential damages caused by improper use of the product, in particular the implied guarantee of
success in the market as well as the suitability of the product for a particular purpose. Furthermore,
burster assumes no liability for direct, indirect or incidental damages or for consequential or other
damages arising from the provision and use of the present documentation.
Trademark information
1-Wire® is a registered trade mark of Maxim Integrated. Windows®, Excel® are registered trademarks or
trademarks of Microsoft Corporation in the United States and/or other countries. PROFIBUS and
PROFINET are registered trademarks of PROFIBUS and PROFINET International (PI). EtherNet/IP is a
registered trademark of the ODVA. All brand names or trademarks mentioned in this document refer
solely to the products concerned and are the property of their respective owners. By mentioning these
trademarks, burster praezisionsmesstechnik gmbh & co kg is not laying claim to trademarks other than its
own.