BR320DABC
27
FM Mode
Selecting FM Mode
1. Press MODE button repeatedly to select FM mode.
2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Otherwise,
the last listened FM station will be selected.
3. To manually change the FM frequency, while FM frequency shows up, press TUNE/VOL.
button to activate tuning function of SCROLL/SELECT knob, and then turn
SCROLL/SELECT knob clockwise or anticlockwise to change the frequency by 0.05MHz per
step.
4. To automatically scan, while FM frequency shows up, press TUNE/VOL. button to activate
tuning function of SCROLL/SELECT knob first, and then turn SCROLL/SELECT knob
clockwise or anticlockwise. Press SCROLL/SELECT knob, your radio will skip forward or
backward until it reached the next available station.
Scan settings
This enables you set FM scans stop at stations with strong signal or stop at any available
station.By default, FM scans stop at any available station. This may result in a poor signal-to-noise
ratio (hiss) from weak stations.
1. Press MENU button, turn SCROLL/SELECT knob to select “Scan setting”, and then press
SCROLL/SELECT knob to confirm.
2. Display will show “Strong stations only?”, turn SCROLL/SELECT knob to select “YES”, and
then press SCROLL/SELECT knob to confirm. The scans stop only at stations with good
signal strength.
3. Turn SCROLL/SELECT knob to select “NO”, and then press SCROLL/SELECT knob to
confirm. The scans stop at any available station. This may result in a poor signal-to-noise
ratio (hiss) from weak stations.
Audio Settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor
signal-to-noise ratio (hiss).
1. To play weak stations in mono, press MENU button, turn SCROLL/SELECT knob to select
“Audio setting”, and then press SCROLL/SELECT knob to confirm.
2. Display will show “Listen in Mono only?”, turn SCROLL/SELECT knob to select “YES”, and
then press SCROLL/SELECT knob to confirm.
To Next Page
Loading...
