What to do if my BWT AQA drink Pro 20 HCS Water Dispenser is leaking?
If your BWT Water Dispenser is leaking water, close the water tap and disconnect the device from the power supply, then contact a service technician, as the water pipes in the device may be defective.
General| Brand | BWT |
|---|---|
| Model | AQA drink Pro 20 HCS |
| Category | Water Dispenser |
| Language | English |
Defines the intended use and purpose of the AQA drink Pro 20 water dispenser.
Explains the operating principle and functions of the AQA drink Pro 20, including water types.
Details the integrated UV system, its function, and indicator lights.
Describes the optional cabinet stand for the AQA drink Pro 20, its features and components.
Outlines warranty terms and BWT's disclaimer of liability for improper use or maintenance.
Specifies responsibilities of the operating party regarding manual adherence and device safety.
Mentions copyright protection for the manual and unauthorized use restrictions.
Emphasizes that only trained specialists should perform installation and maintenance.
Instructions for unpacking and checking the AQA drink Pro 20 for completeness and transport damage.
Steps for preparing the purifier, including placement and drip tray setup for tabletop/floor versions.
Guidance on installing the filter, recommending BWT filters for optimal performance.
Detailed steps for connecting to the water supply and initial system filling and priming.
Instructions for installing or replacing the CO2 cylinder and powering on the device.
How to adjust the cooling temperature, with a note on preventing icing.
Recommends service intervals for cleaning, filter replacement, and UV lamp changes.
Details required sanitation procedures and the importance of regular cleaning by trained personnel.
Instructions for handling periods of inactivity, including draining and flushing the system.
Step-by-step guide for safely replacing the UV lamp, including precautions.
Covers preparing the filter, rinsing, and initial reaction of the disinfectant.
Details emptying the carbonator, rinsing water lines, and initial CO2 handling.
Describes CO2 discharge, ambient line rinsing, and UV function checks.
Instructions for draining the hot water boiler and refilling it.
Covers stopping the process and advancing to the next step.
Covers preparing the filter, rinsing, and initial reaction of the disinfectant.
Details rinsing water lines and CO2 discharge procedures.
Describes line rinsing, reset, UV check, and boiler draining.
Instructions for draining water and refilling the boiler and ice bank.
Covers stopping the process and advancing to the next step.
To Next Page
