What to do if my BWT Water Dispenser shows CHECK and SALT?
If your BWT Water Dispenser displays 'CHECK' and 'SALT' alternately, it means either the salt tank is empty or the device has detected a regeneration issue. First, refill the salt tank. If the display persists even after refilling, it is recommended to contact technical support for further assistance.
Why is my BWT A6X not softening water?
If your BWT Water Dispenser isn't softening water effectively, with limescale returning, there could be several reasons. First, ensure the bypass is correctly positioned to direct water through the softener. Next, check and refill the salt tank if it's empty. Verify the salt type selected in the programming is correct and that the filter element isn't clogged—replace it if necessary. If issues persist, contact technical service.
What to do if my BWT A6X has no display?
If there's no display on your BWT Water Dispenser, it could be due to a power outage or an electrical/electronic failure. Begin by checking the power outlet to ensure it's working. If the outlet is functional and there's still no display, contact technical support.
Why is water flowing through the evacuation tube of my BWT A6X?
If water is flowing through the evacuation tube of your BWT Water Dispenser, it could be due to the device regenerating, which is normal. Check if the display shows REGE 1, REGE 2, or REGE 3. If it doesn't show these, contact technical support.
What causes water overflow from the salt tank in my BWT A6X?
If the salt tank in your BWT Water Dispenser is overflowing, it indicates a problem with the brining chain, possibly a closure issue or leak. Check the connection between the brining tube and the brine valve. If the issue continues, contact technical support.
What to do if my BWT A6X shows 'CHECK' and 'SALT'?
If the BWT Water Dispenser displays 'CHECK' and 'SALT' alternately, it indicates that the salt level in the tank is low or the device has detected a regeneration error. First, refill the salt tank. If the message persists after refilling, it's recommended to contact technical support for further assistance.
Why is my BWT A6X Water Dispenser not softening water anymore?
If the water from your BWT Water Dispenser is no longer softened, indicated by limescale returning, several factors could be at play. Measure the residual hardness, and then check the following: Ensure the bypass is correctly positioned to direct water to the softener. Verify and refill the salt tank if it's low. Inspect the filter for clogs and replace it if necessary. Redo the blending procedure as described in the commissioning chapter. If the issue persists after these steps, contact technical support.
What to do if there is water overflowing from the salt tank of my BWT Water Dispenser?
If there's water overflowing from the salt tank of your BWT Water Dispenser, it suggests the brining chain isn't closing properly or is leaking. Examine the connection between the brine tube and the brine valve. If the overflow continues, contact technical support for assistance.
How to correct the time on my BWT Water Dispenser?
If the time displayed on your BWT Water Dispenser is incorrect, it may be due to a missed seasonal time change or a power outage that affected data recovery. Reset the time as described in the 'SETTING' chapter. If the problem recurs, contact technical support.
What to do if there is no display on my BWT Water Dispenser?
If there is no display on your BWT Water Dispenser, it could be due to a power issue or an electrical/electronic failure. Verify that the power outlet the device is plugged into is working. If the outlet is functional and there's still no display, contact technical support.
General| Brand | BWT |
|---|---|
| Model | A6X |
| Category | Water Dispenser |
| Language | English |
To Next Page
