ECB16 ECB18
9 OM-ECB162015006-EN-US
(12) hazards due to production of carbon monoxide by internal combustion engines and
common initial symptoms of exposure
(13)
fueling and battery charging
(14) guards and protective devices for the specific type of truck
(15) other characteristics of the specific industrial truck
2. operating environment and its effect on truck operation including
(1) floor or ground conditions including temporary conditions
(2) ramps and inclines, with and without load
(3)
trailers, railcars, and dockboards (including the use of wheel chocks, jacks, and other
securing devices)
(4) fueling and battery charging facilities
(5)
the use of “classified” trucks in areas classified as hazardous due to risk of fire or
explosion, as defined in ANSI/NFPA 505
(6)
narrow aisles, doorways, overhead wires and piping, and other areas of limited
clearance
(7)
areas where the truck may be operated near other powered industrial trucks, other
vehicles, or pedestrians
(8) use and capacity of elevators
(9) operation near edge of dock or edge of improved surface
(10) other special operating conditions and hazards that may be encountered
3. operation of the powered industrial truck, including:
(1)
proper preshift inspection and approved method for removing from service a truck
that is in need of repair
(2) load handling techniques: lifting, lowering, picking up, placing, tilting
(3) traveling, with and without loads; turning corners
(4) parking and shutdown procedures
(5) other special operating conditions for the specific application
4. operating safety rules and practices including:
(1)
provisions of this Standard in
Operating Safety Rules and Practices address operating
safety rules and practices
(2)
provisions of this Standard in
Operating Safety Rules and Practices address care of
the truck
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
