iNetVu New Gen Troubleshooting Guide
C-COM Satellite Systems Inc.
RF Signal Not Being Detected (Single IFL Cable Setup)
RF Signal in Yellow/Red: (Abnormal State)
This indicates the controller is not configured correctly, and you will not be able to deploy the dish
resulting in ERROR 0X8915 - RF IS TOO LOW. Ensure the controller is configured correctly (Tooway
or SurfBeam 2 Auto Acquire) using the Quick Start Guides. Otherwise proceed to Step 2.
Diagram for Single IFL Cable (TX Only)
goes to TRIA
To Next Page
Loading...