12 12
4 Loading Material
Notice!
For adjustments and simple installation work, use the accompanying Allen key located in the upper section
of the print unit. No other tools are required for the work described here.
4.1 Loading Labels
Fig. 7 Loading labels Fig. 8 Label feed path
1. Open cover.
2. Turn levers (3, 10) counterclockwise to open the printhead (1) and the backfeed system (9).
3. Move guide rings (4) outwards until the media can pass between the rings and the mounting plate.
4. Guidelabelstrip(8)tothepeel-offedge(2)asshowninthegure8andmovetothemountingplateuntilitstops.
The printing side of the label must be shown from above.
5. For peel-off mode forward the label strip over the peel-off edge, that the strip reaches back to the locking system
(5). Remove the labels from the overhanging strip.
6. Turn levers (3, 10) clockwise to close the printhead (1) and the backfeed system (9).
7. Slide guide rings (4) against the label strip.
Notice!
For a good label tracking it is necessary to brake slightly (about 3 N) the incoming material. This must be
done outside of the print module.
8. For peel-off mode pull the knob (6) and swing downward the locking system (5). Guide the liner (7) from the
peel-off edge (2) over the locking system (5). Tighten the liner, pull the knob (6) and swing the locking system
upwards. Ensure that the knob snaps in completely into the side plate.
9. Close cover.
To Next Page
Loading...
Need help?
General
