10 10
4 Replacing Assembly Units
4.1.2 Replacing the Printhead XC6
2
3
5
4
1
4
1 Printhead
2 Plug connection
3 Plug connection
4 Threaded hole
5 Printing line
Fig. 5 Structure of the printhead XC6
Attention!
The printhead can be damaged by static electricity discharges and impacts!
Ground your body, e.g. by wearing a grounded wristband.
Do not touch contacts on the plug connections (2, 3).
Do not touch printing line (5) with hard objects or your hands.
i
Notice!
The printhead replacement will be described for the upper printhead. The procedure applies for the lower
printhead in the same manner, but the print roller must be removed additionally.
7
44 12 3
6 6
Fig. 6 Replacing the upper printhead XC6
Removing the printhead
1. Lift the printhead.
2. Remove labels and transfer ribbon from the printer.
3. Lightly keep printhead mounting bracket (7) on the print roller with one nger and loosen screws (6)
4. Swivel printhead mounting bracket (7) upward.
5. Remove printhead from the printhead mounting bracket (7) if necessary.
To Next Page
Loading...
Need help?
General
