Changing Units of Measurement
T h e DigiRoller/DigiRoller Plus can display and convert
between the following units of measurement:
■ Feet-Inch
■ Decimal Feet
■ Inches
■ Yards
■ Meters
■ Acres (for displaying area values only)
You select your preferred measuring unit with the [Units] key.
Each press will advance through the above unit settings.
Any measurement on the display can be converted to the
desired unit of measurement by pressing the [Units] key. For
example, if the display shows:
and you would rather see the value displayed in inches, press
the [Units] key. You will see:
You can select different units of measurement for each mea-
surement convention (linear, square, cubic) just by pressing
the [Units] key while displaying any linear, square or cubic
value. The units of measurement you choose will remain as
they were last displayed until you change them (even if you
turn off the DigiRoller/DigiRoller Plus).
11 – User’s Guide
To Next Page
Loading...
Need help?
General
