Taking Volume Measurements
The DigiRoller Plus is programmed to quickly and easily cal-
culate volumes if you’ve rolled in a height or if you’ve set a
fixed height.
You can roll or set a height for each of the nine Area Number
storage registers. Once you roll or set a height, it is used for all
subsequent volume calculations unless you change it.
Remember to press [RESET] to begin each new measurement.
Calculating Volume Using a Rolled Height
Step: Key:
Roll length [L]
Roll width [W]
Roll height [H]
Find volume [LxWxH]
22 – DigiRoller/DigiRoller Plus
™
To Next Page
Loading...
