Deleting Stored Measurements
To permanently delete a stored value, press the delete key
[DEL] and then the key that has the value you want to delete.
Be careful when pressing the [DEL] key, as it will permanent-
ly erase the stored value of the next key pressed.
If you accidentally press the [DEL] key, press [RESET] to pre-
vent any stored value from being erased.
Using the Counter
The DigiRoller/DigiRoller Plus has a manual “count” function
that allows you to count various items you may be tracking as
you roll your measurement (for example, parking spaces, fire
hydrants, etc.).
When you want to count something, press the [Count] key. If
the bell is on, the unit will beep each time you press the
[Count] key and the count total in the upper left corner of the
display will increase by 1. To subtract a count, press the [Set]
key then the [Count] key.
16 – DigiRoller/DigiRoller Plus
™
To Next Page
Loading...
