Storing and Recalling Values
The DigiRoller/DigiRoller Plus has several keys that can be
used to store and recall values:
The DigiRoller Plus can also store and recall values in the [H],
[LxWxH], [AutoCount], and [Area#] keys.
To recall any of the values above, press the [Rcl] key and then
press the key that has the value you want to display. For
example, to recall the length that was rolled, press [Rcl] [L].
Storing Measurements
in Permanent Memory
You can store rolled measurements in the standard calculator
type memory, by pressing the [M+] key after rolling. To sub-
tract a measurement from a previously stored value, press the
[M-] key after rolling. To recall the total stored in Memory,
press [Rcl] [M+].
NOTE:
This memory feature acts just like a standard, limited calculator memory
function; it will accumulate and total the measurements added to it.
15 – User’s Guide
To Next Page
Loading...
