3) When you are finished measuring, press the [Start/Stop]
key again.
4) To store the measurement, press the appropriate key (ex.
[L] for length, [W] for width). If you do not store the mea-
surement, you can then press the [Start/Stop] key again to
continue measuring.
5) If you have stored the measurement, press the [Start/Stop]
key to begin a new measurement. If you didn’t store the
measurement, press the [RESET] key to clear the display
then begin rolling.
14 – DigiRoller/DigiRoller Plus
™
To Next Page
Loading...
