Continue the above steps for each area you wish to calculate
and store, up to 9 areas.
If you try to store a tenth value, the word “FULL” will dis-
play. Press [RESET] to clear this error message. If you want to
add this last value, you must then delete and/or edit the val-
ues stored in the Area Number registers. See the “Editing
Stored Measurements” section for information on editing val-
ues in the Area Number registers.
Recalling Stored Measurements
To review your stored areas, press [Rcl] [Area#]. The last Area
Number measurement that you stored or recalled will be dis-
played. Once you press these two keys, you can review all
stored values for each Area Number – length, width, height,
area, volume, wall area and totals for each.
Step: Key:
Area# 1 [Rcl] [Area#] (until Area# 1 appears)
Recall length [L]
Recall width [W]
Recall area [L X W]
27 – User’s Guide
To Next Page
Loading...
