Need help?Do you have a question about the Calnex Sentinel and is the answer not in the manual?
Outlines general safety procedures for correct and safe operation of the instrument.
Stresses proper grounding for safe operation and warns against interrupting the ground connection.
Guides through connecting sources, powering up, and the initial identification screen.
Guides on configuring the measurement subsystem based on testing requirements and installed modules.
Details tabs for configuring measurement subsystems and common options, with OK, Cancel, Apply buttons.
Explains applying predefined masks to TE, TIE, MTIE, TDEV graphs for result analysis.
Details how to start, stop, and program measurements, including default characteristics.
Explains saving measured data to instrument or USB, and post-processing.
Guides on obtaining and installing firmware updates via the instrument's USB interface.
General| PTP/IEEE 1588 | Yes |
|---|---|
| Product Type | Analyzer |
| Protocols Supported | PTP, SyncE, NTP |
| Phase Measurement Resolution | 1 ps |
| Time Measurement Resolution | 1 ps |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Operating Temperature | 0°C to 50°C |
| Dimensions | 19" rack mountable, 1U height |
To Next Page
