Instructions
CX3001 v7.0 © Calnex Solutions 7
Antenna
GNSS antenna connector
1 PPS in – TTL / 50
External 1 PPS phase reference input.
1 PPS out – TTL / 50
Internal 1 PPS timing output from Rubidium oscillator.
E1/T1 clock output (MHz)
User settable E1 or T1 clock output, BNC 75.
E1/T1 framed output (Mbit/s)
User settable E1 or T1 framed output, isolated BNC 75.
External reference
Input for precision external reference (1, 5 or 10MHz clock).
Reference signal output
10MHz frequency from the internal reference or the external reference (if selected).
Ethernet network connector
Standard RJ45 connector for connecting the instrument to a PC or LAN using the
10/100BASE-T protocol, enabling remote control over Ethernet.
USB type B connector (for future use)
USB Device port
USB type A connector
USB Host port
10GbE packet module
Up to 2 channels per module, RJ45 or SFP connectors
Accessories delivered with the instrument
• Line power cord
• GNSS Antenna and 20m cable
• User Guide & CAT Analysis software on USB stick
To Next Page
Loading...
