EasyManua.ls Logo

Calorex Pro-Pac PPT45EHC - Plumbing and Water Connections

Calorex Pro-Pac PPT45EHC
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. PLUMBING
The Calorex pool heat pump must be connected aer e filter in e
return pipe to e pool. If an existing heater is being retained, en e
Calorex should be connected between e filter and e oer heater.
(See Figures 3 & 4).
1. Calorex heat pumps have water inlet/outlet connections as follows:
2. Suitable breakable couplings should be installed local to heat pump.
3. If heat pump installed at lower level an pool water en isolation
valves should be fitted
4. A drain valve or plug should be fitted to lower pipe to facilitate drain
down in winter period.
5. The condensate drain at e base of e unit collects e
condensation from e evaporator fins.This should be run away to
waste via 1½" domestic waste piping. It is erefore necessary to
ensure at e Calorex Heat Pump is placed on a level plin so
at e condensate later can run away and not overflow e edges
of e drip-tray inside e machine.
6. When e pipework installation is complete e pool pump should
be switched on and e system tested for leaks. Also check
e filter gauge to see at ere is not an excessive increase in
back pressure. If everying is en working normally e water
circulating system is ready to use.
7. Water circuit to and from unit to be capable of maintaining wiin
specified limits e rate of flow required by heat pump (see data
sheet).
8. All pipework must be adequately supported wi allowance for
expansion/contraction especially wi plastic pipework.
9. It is recommended at when installing water system e last
connections to be made in e system should be e breakable
couplings to avoid any stresses on to e unit connections.
CORRECT DRAINAGE
FOR CONDENSATE
ELBOW
'U' TRAP
SUPPLIED BY
CONTRACTOR
ADEQUATE FALL
MODEL Water in/out
connection size
MODEL Water in/out
connection size BHC
Water in/out
connection size EHC
Pro-Pac PPT 30 2" UNION SOCKET 1½ BSPM
Pro-Pac 45 1½ BSPM Pro-Pac PPT 45 2" UNION SOCKET 2" BSPM
Pro-Pac 70 1½ BSPM Pro-Pac PPT 70 3" BSPM 2" BSPM
Pro-Pac 90 1½ BSPM Pro-Pac PPT 90 3" BSPM 3" BSPM
Pro-Pac 140 2" BSPM Pro-Pac PPT 140 4" BSPM 3" BSPM
8
SD566250 ISSUE 35
PR0-PAC SYSTEM OWNER INSTALLATION MANUAL

Related product manuals