17
Surface sizes
Argo S & Argo Q surface sizes, are stated
in the number of standard faders they can
contain. A number of sections are fitted
together to provide a control surface of
a suitable width to contain the number
of faders required, or to fit the physical
space available.
Often consoles' are ordered to be larger
than is required at the time to allow for a
future increase in the quantity of faders.
Consoles come in a variety of widths and
are defined by the number of 12 fader
FIG 9 - LEG MEASUREMENTS - FRONT ELEVATION FOR ARGO S & ARGO Q
wide control panels that they can contain
across their width.
Up to 8 x 12 fader wide sections can be
fitted into a chassis.
A standard Argo S or Argo Q layout,
consists of a number of standard fader
panels across the bottom, 1 row(Argo S)
or 2 rows (Argo Q) of the various Wild
Assign panels/Short fader panels or
Monitor panels across the middle, a row
of TFT touch panels above these and a
row of TFT Meter display panels across
the top.
The IU6576 standard fader panel is
378.5mm [14.90'] wide and is fitted
with twelve faders across its width,
see "Argo S Surface" on page 10
& "Argo Q Surface" on page 11 for
example layouts.
Leg Measurements
Fig 9 & Fig 10 shows the Internal
and External Legs and the Surface
measurements for the distances between
the support legs for the total width of
each console size from 2 to 8 sections
wide.
The example shown below in Fig 9 is a 3
section Argo S console on its stand.
To Next Page
Loading...
