Calrec ARGO - TFT Touchscreen Panel - MU6572

72 ARGO Digital Broadcast IP Production Console
Panel Options
TFT TOUCHSCREEN PANEL - MU6572
MU6572 - ARGO S & ARGO Q TFT TOUCHSCREEN PANEL
DISPLAY CONNECTOR LAYOUT Connections
This panel has three separate connectors
for touch, power and video display placed
on the back of the panel.
The TFT Touchscreen Panel connects
to the UN6539 section processor which
provides:
Touch control via a USB 2 Type B
connector.
Power Input via a 4 pin 12v DC connector.
Video display data via a DP Display port
1.4 Interface using a full size DP latching
connector.
The MU6572 TFT Touchscreen panel
provides the Argo S/Argo Q with a
graphical user interface to provide a
1920px x 1080px TFT video display
and touch circuitry, touch control
and display of the various control
parameters of the console. These
panels are generally fitted across the
required surface size.
The MU6572 is 378.5mm wide x 228mm
high and uses a 1920px x 1080px TFT to
display rendered graphics and composited
video data generated on the section
processor via the DP Display port 1.4
interface. It is fitted with a multi-touch
digitiser circuit also connected from the
Section Processor via USB that allows
the user to select operations from a menu
based GUI and to use touch control to
adjust the console parameters.
It can also optionally display Input video
via the Video SFP inputs on the section
processor.
The image below shows an example of an
interactive Equaliser page, with the sliders
and buttons controllable via touch.
The Display backlight level and enable
control are provided using baseband
signalling over unused DP pairs on the DP
connector.